This is the BAMA archive. These manuals are available for download and free of charge. Do not be tricked into paying for a manual that is available here for free.
-
2026-10-09
- 170 new manuals added in aes, alinco, bitsavers, b&k, century, collins, dovetron, ebooks, eico, electric-eye, freq-electronics, goodwill, hickok, johnson, kantronics, micronta, military, national, rca, scientific_radio, sencore, sylvania, tennelec, triplett, uniden, and xyz.
-
2026-10-21
- New beta site for public review.
adv-mod
00readme
Adventurer Modulator manual compliments of Gary Schafer, K4FMX
adventurermod
A. MODIFICATION OF ADVENTURER. Refer to figures 1, 2, and 5 in
the ADVENTURER instruction manual.
1. ( ) Remove fourteen #6 sheet metal screws around the edge
of the Adventurer front panel. Remove four #6 sheet
metal screws just outside the two large cutouts on the
rear of the Adventurer cabinet. Remove cabinet from
Adventurer.
2. ( ) Remove R11, 20,000 ohm 10 watt wire wound resistor
(Figure 5 in Adventurer Instruction Manual) from
terminal 2 of the terminal strip X6 and pin 2 of
socket X2. Leave 3/8" leads on R11 and save it for
use in Modulator kit. Resolder terminal 2 of X6.
3. ( ) Cut an 8" length of #20 red plastic covered wire.
Strip ends 5/16". Connect this lead from pin 6 of
octal socket X4 (on the rear of the chassis) to pin
2 of 807 socket X2. Train this lead from X4 along
the chassis toward X3, then between terminal strip
X6 and 807 socket X2, passing under a single read
lead, Y35, near the #5 end of X6, then up to pin 2
of X2 (S). Solder at pin 6 of X4.
4. ( ) Inspect wiring in areas just modified for soldering
and possible shorts. Replace cabinet on Adventurer.
Files
Contact and submissions
If you have a better copy of any of these manuals, or a manual which is not listed, and wish to share it, upload it to cloud.edebris.com or email the archive directly. All formats are accepted.
BAMA is offered as a free service to the internet community. Please respect the archive and its download limits.
Viewers
These viewers may be required to read some manuals in the archive:
- Sumatra PDF (Windows)
- DjView (DjVu)
- WinDjView (Windows, DjVu)
- Adobe Acrobat Reader (PDF)